





This home in Colleyville had two electrical panels - which meant a standard single-transfer-switch setup wasn't going to cut it. The homeowner wanted true whole-home coverage, so we installed a Generac standby generator paired with two automatic transfer switches, one for each panel. That way, when the grid goes down, everything stays on.
Here's what makes the dual ATS setup worth understanding. An automatic transfer switch is what tells your generator to kick on the moment it detects a power loss. With two panels in play, you need a dedicated ATS for each one. Skip that and you're only protecting part of your home - the other half goes dark. We don't take shortcuts like that.
The Generac unit itself sits on a solid concrete pad, mounted low and clean against the brick exterior. The conduit runs are organized and secured tightly to the wall, with both ATS units clearly labeled for emergency disconnect. It's the kind of install where everything has a place and nothing looks like an afterthought.
Texas weather doesn't give much warning. Ice storms, summer grid stress, severe thunderstorms - outages here aren't rare. A whole home generator means your HVAC keeps running, your refrigerator stays cold, your lights stay on, and your family isn't scrambling for candles at 11pm. It's a practical upgrade, not a luxury one.
A setup like this is more involved than a basic generator drop. It takes real electrical knowledge to integrate dual transfer switches correctly and make sure both panels are protected without conflicts. That's exactly the kind of work we do every day.